What if there is communication problems when using USB
If you are experiencing communications problems, check to see if the USB 2.0 drivers are installed using the Device Manager setup.
In Windows Device Manager, verify that a BPM Microsystems Programmer Site exists for each programmer site that is attached and powered on.
Drivers are available on the CD ROM supplied with your equipment.
Any new site that is attached should automatically be detected by Windows too.
Related Articles
No communication with Cyberoptics system
Summary Handler cannot initialize because of lost communication with Cyberoptics system DetailsNot to be confused with Cyber Status 5 (no communication between the SCM board and the Camera) Typical log file snippet: 2010-10-18 13:23:18 -0800 Cyber ...
TS1500 - USB Communication Problem
If you are experiencing issues with obtaining communication via USB to your TS1500 tray Stacker, then please read the following information. You need to ensure that the driver is correct and that you have only one instance of DUB-E100 listed in ...
How reliable is the USB bus
USB 2.0 is extremely reliable. All data transactions are integrity checked using the very comprehensive CRC32 calculation. Additionally, the USB hardware will retry any packets that fail the integrity check during transfer. This makes the USB bus ...
What is the best way to remove other USB devices connected to the same hub as the programmer
When removing other USB devices (for example, Flash Drives) connected to the PC while a USB programmer is actively engaged in an operation, use the "Safely Remove Hardware" icon in the Windows system tray first to avoid potential communication ...
Reducing upload and broadcast times for ultra large data files on USB site Autohandlers.
Having received complaints about the lengthy upload time and broadcast time for large data files, BPM have discovered that the ports that the site USB cables are connected to can makes a big difference in process speed. Refer to the attachment for ...